NSRTW_mk3
User’s Manual
29
7.6.3
WiFi
Settings (Without Cloud Service)
The
WiFi
settings panel appears when the
Set WiFi
button is pressed. The
WiFi
settings are used to
configure the Router(s) or Access Point(s) to connect to, the Server’s IP address or domain name, and
the periodic connection schedule.
Figure 10
WiFi Settings
7.6.3.1
Schedule
Whether it is recording or idle, the instrument can activate its
WiFi™
interface and try to connect to a
server at regular intervals. The connection schedule is defined in that field. In order to enable that
behavior, the following must be setup:
•
The Connect Interval must be set:
The interval is often
chosen as once per hour, or once per 10 min. Setting a very small interval will let the
instrument report much more often, but that will drain the battery faster. Setting a much longer
interval (several days, a week or more) will risk losing data if the connection cannot be
established at its scheduled time. The interval must not be set as 0. We do not advise setting a
schedule interval lower than 2 min.
•
The WiFi-Report-Active button must be pressed:
When the button is
released the instrument will not try to connect at the set interval.
•
A start date and time must be set sometime in the future:
The periodic connection
attempts will only begin at the set date and time.
7.6.3.2
Access Point
The coordinates the access point or
WiFi™
router can be set, with its security method, password, and
priority. Each router or access point is defined by its
SSID
.
When security is used, a password must be entered.
Note:
By clicking on the little grey block at the left of the pass-phrase field, several input methods can
be selected:
