10
Installation and Mounting
1. Insert the supply cable through the
strain relief of the installation cover.
Remove 1.97 inches (50 mm) of the
outer insulation, and .4 inches (10 mm)
of the inner insulation.
50mm
10mm
(.4 in.)
(1.97 in.)
2. Connect the grounding wire to the chassis
using the designated grounding screw.
3. Cut two 30 mm pieces of the insulating
sleeve and slide over the line wires of
the supply cable. Connect each lead to
the corresponding wires on the heater,
using the wire nuts provided (see
Electrical Wiring
, page 12.)
! NOTE:
The insulating sleeve,
supplied with the product, must be
placed over the exposed line wires of
the supply cable.
®
(4) 1½" Screws
Stud Finder
(Optional)
#2 Phillips
Screwdriver
(4) Wall anchors (if needed):
must be suitable for
min. 50 lb / 22.7 kg
Wire Strippers
Utility Knife
Wire Connectors
Tape Measure
Level
TOOLS REQUIRED
Summary of Contents for 51FLB 00-C10-BB
Page 2: ...2...
