REMOTE CONTROL
Preparation before operation
During Operation
Step 1:
Step 2:
Remove the battery cover and insert
new batteries
.
The remote display will alternately
flash
by p
To change the setting, remove the batteries
and press the “ON/OFF” button, then repeat
steps 1 and 2.
Your remote control is now ready for use
If there is no display, or only part display,
remove the batteries and repeat steps 1 and
2 above. If this does not solve the problem
and the batteries have been replaced,
contact your nearest service centre for
advice.
(AAA), making sure the + and -
match the compartment markings (Fig 10)
“COOL” or “HEAT”.
Select the
operating mode to match your cooler type.
ressing the MODE button when the
correct setting is displayed.
If the display disappears, or the remote
control will not operate the air conditioner, the
batteries may need to be replaced.
The Supercool must be plugged in and
switched on for the remote control to operate
the air conditioner. To use, point at the signal
!
!
Select “COOL” for Supercool NR, TRB or FR
Select “HEAT” for Supercool TRC
Note!
Signal
transmission point
Display area
On/Off button
Mode button
Clock button
Fan speed
adjust button
Hold button
Battery
compartment
Battery cover
Swing button
Minute button
Hour button
Timer button
Temperature
increase/decrease
buttons
receiving window on the control panel and
press the remote button. The air conditioner
will “beep” when a signal has been received.
If there is no beep, press the remote button
again, ensuring it is within range (6 metres) of
the air conditioner.
If there are two of the same air conditioners
installed, they cannot be controlled
separately. When you operate either
remote, it will turn on both air conditioners if
they are both within signal range (6 metres).
Don’t let the remote control drop onto hard
surfaces or be subjected to sudden shocks
in any way. The warranty does not cover
misuse or accidental damage.
Don’t place the remote control in direct
sunlight, or near extremes of temperature.
This will affect the control’s temperature
reading.
Don’t allow the remote control to get wet.
Don’t place near strong electromagnetic
waves.
Don’t mix old and new batteries
!
If the
remote control will not be used for a long
time, remove the batteries to avoid
corrosion.
Care of your remote control
!
NOTE:
WASTE BATTERIES SHOULD
BE DISPOSED OF CORRECTLY
9
10
6
Summary of Contents for Supercool
Page 2: ......
