Assembly Instructions
Unpack the heater and make sure it is
undamaged and all components are
present.
Your heater
be assembled for either
the Portable or Wall Mounting option
before use, and not be free standing.
Turn the heater
upside down and assemble the two leg
supports by unscrewing and then re-
fixing with the wing-nut as shown (Fig.
1-3). Ensure both wing-nuts are
tightened firmly and the castors are
secure before using the heater.
Note: the longer leg section is at the rear
of the heater as shown.
must
Portable Assembly:
Fix the wall bracket securely to the wall
through the 4 screw holes provided (Fig
6).
Raise the heater onto the bracket,
engaging the 2 bottom tabs of the wall
bracket first.
Ensure the bottom tabs
slide up into the heater rear panel and
lock into place (Fig 7).
Component List
A Front Panel
B Control Panel
C Display Panel
D Power Switch
E Rating Plate
F Leg Support (x 2)
G Back Panel
H Wall Mounting Bracket
I
Power Cord
J Remote Control
2
CPH Series Portable Heaters
ASSEMBLY
B
D
E
H
A
F
J
C
G
I
Wall Mounting Assembly
NOTE: the wall mounting bracket
supplied with the heater must be used.
Because wall types differ, mounting
hardware (screws and wall anchors) are
not supplied and will need to be
purchased from your local hardware
retailer. Please use the following fixed
weights as a guide:-
Model CPH01B/W/M:
9.3 kg
Model CPH02B/W/M:
12.6 kg
There are 4 fixing points that must be
used.
The heater must be positioned so it
complies with the minimum clearances
shown in Fig 4.
Loosen the 2 screws from the top of the
mounting bracket (refer Fig 5), then
push down on the top and bottom tabs
to release the mounting bracket from
the rear panel
ASSEMBLY
cont.
®
SEELEY INTERNATIONAL
–
OWNER’S MANUAL
3
3
1
2
1
Longer leg
section to the
heater’s rear
4
450mm
150mm
250mm
5
6
4 fixing points
/ screw holes
7
Engage bottom
tabs first
