controlair SH600X, Manual For The Installation, Use And Maintenance, Page: 12 / 18

12
Hood installation on walls (Fig.1, Fig.2, Fig.3)
Notes: The figures mentioned in this manual are in the first pages.
If the height from the Hob to the hood in the instruction user manual of the
hob supplier is higher than the hood template, follow adhere to the hob sup-
plier info.
For gas cooking appliances only: the minimum distance to the hood
must be at least 65 cm.
The screws and bolts supplied for attaching the hood to the wall are for solid
masonry walls. For other types of wall, the suitable means should be used.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
It is recommended that there are no bends in the outlet tube, and that there is a
distance of less than 1 metre between the hood outlet and the bend.
The above restrictions do not apply to hoods with no fumes outlet to
outside (recirculation system with activated charcoal filter). (fig. 7)
Use of the hood - Control panel (Fig.4)
The different control panels are described below. Check the panel model
installed on your hood and see the figure indicated in each case.
Five-button panel (P1)
1-
Extractor fan operating control pilot light.
2- Lighting on and off.
3- Extractor fan off.
4- Extractor fan speed - button: speed 1, 2 and 3,
Panel with sliding switch (P2)
1-
Extractor fan speed - positions: OFF, speed 1, 2 and 3
2- Extractor fan operating control pilot light.
3- Lighting on and off switch.
Hood maintenance
Warning: always switch off the electricity supply before carrying out
maintenance work on the hood. In the event of a fault, contact an official
distributor or authorised dealer.
Cleaning the outside: use liquid, non-corrosive detergent and avoid using
abrasive cleaning products and solvents.
Do not use high-pressure or steam cleaning devices.
Grease filters (Fig. 5): to avoid fires, clean thoroughly once a month or
whenever the display pilot light indicates as such. To do so, remove the
filters and wash with hot water and detergent. If using a dishwasher (metal
parts may turn black without this affecting their functional capacity), load the
filters vertically to avoid solid residue from being deposited.
Activated charcoal filters: replace the every 3 months.
Important: increase the filter cleaning/replacement frequency if the hood
is used for more than 2 hours a day. Always use genuine filters from
the manufacturer.
Bulb replacement (Fig.6)
Warning: do not handle the bulbs until the electricity supply has been
switched off and they have cooled.
Important: use new bulbs according to that indicated on the hood
nameplate.
If using LED lighting, do not look directly at the light.
Use bulbs with an aluminium reflector to replace halogen bulbs. Do not
use dichroic bulbs - risk of overheating.
For LED lamp replacements, please contact Technical Support or the distribu-
tor of the brand.