
FSG/MTM/001 060511
159
When replacing, gently press the Exit Roller Shield downwards while tightening the fixing
screws.
8.10 Mirror Chassis
Remove all Covers.
Turn scanner upside down.
Remove the brackets with the two rear rubber feet.
Remove the four 4 mm nuts and washers (on the outside of the side plates) that hold the
Mirror Chassis.
Pull out the four tight-fitting bolts (two at each end).
The Mirror Chassis is now free to be lifted out.
To replace the Mirror Chassis, reverse the order of removal.
Always clean the mirrors before replacing the Mirror Chassis.
After replacement of the Mirror Chassis and Covers:
Check Camera Adjustment, Chapter 4.2, page 86
, especially Vertical Positioning, Section
Run Scanner Maintenance.
8.11 Reflector Assembly
Remove all Covers.
Remove Glass Plate.
This is to prevent scratching of the Glass Plate when removing and replacing the Reflector
Assembly.
Remove the Fluorescent Lamp.
Turn the scanner upside down
Do not grip on the Mirror Chassis
.
Remove the Mirror Chassis.
Disconnect the cable from the OSB-Board.
Push the plug down through the cutout in the Reflector Assembly. The cable is now free to be
pulled out through the opening in the side plate.
To re-install the cable grip the plug with flat-nose pliers and - through the opening in the side
plate - push the plug up though the cutout in the Reflector Assembly.
Remove the 12 screws that hold the Reflector Assembly.
Summary of Contents for CHAMELEON 25
