Contemporary
Research
6
ICC-ZS2 Zenith SuperPort Card
Using the IC-RC Remote for On-Screen Menus
In order to complete the setup, you’ll need the IC-RC IR Remote to use the On-Screen Menus. Typically, the
remote is shipped ready to communicate to Smart TV. Just in case, here’s how to set the IR codes in the
remote:
1.
Press and hold the Select button and a numeric key for the code # below.
2.
Release the two keys at the same time.
3.
The remote will now send the selected codes.
4.
Remote will keep the codes, even if battery power is lost.
IR Code Format
Code
Zenith Smart TV
1
LG/Zenith Smart LCD
5
On-Screen Setup Menus
The remaining installation steps use the IR remote and the TV’s built-in character generator.
1.
Touch
Menu
, then
999
, then
Enter
.
2.
The text
CR MENU>
should appear on the screen.
3.
Key in one of the commands shown below, then press
Enter
to activate.
4.
Note that, in Menu mode, the
Channel Down
key acts as a backspace/delete key and
Channel Up
can act as an
Enter
.
Command Function
All
The following commands are used for all units
45677
Display firmware base data (variations for LG models)
45678
Display firmware version
45679
Display the unit’s Device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with the remote’s numeric keypad, then hit Enter
to save the new number.
65478
Reset unit, similar to disconnecting power then restarting.
65479
Disable smart port communication. After about 5 seconds the TV will drop
communication with the TV controller and revert to stand alone TV mode. At this
point, the installer can switch to the TV Mode on the remote control, and then
adjust the TV setup parameters. To re-enable smart port, press
Record
on IC-RC.
65487
Initialize to factory default settings: Power on, unlocked, display channel 11,
channel ring set to 4, 5, and 11, Group 0. Note that this command works even if TV
power is off or control is locked out.
65482 Shows
Net RX
if receiving the iC-HE’s “heartbeat” pulse once per second,
!NET RX
if not. Also displays receive signal strength in the ICC2.
ICC2
The following commands are used for the ICC2 only
65480
Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the ICC2 unit’s RF output. Press Enter to stop transmitting, or the unit
will automatically stop after 50 seconds.
65481
Display ICC2 transmitter frequency control voltage – should be 2000 - 3150.
65483
Display DF transmitter frequency deviation – should be 245 - 300.