Contemporary Research Co
7
ICC-PSC Philips Smart Card
Using the IC-RC Remote for On-Screen Menus
In order to complete the setup, you’ll need the IC-RC IR Remote to use the On-Screen Menus. Typically, the
remote is shipped ready to communicate to Smart TV. Just in case, here’s how to set the IR codes in the remote:
1.
Press and hold the Select button and a numeric key for the code # below.
2.
Release the two keys at the same time.
3.
The remote will now send the selected codes.
4.
Remote will keep the codes, even if battery power is lost.
IR Code Format
Code
Philips Smart TV
2
Philips Previous Channel
Some Philips models will not respond properly to the IC-RC’s PrevCh command, marked as A/CH on the Philips
IR remote. If this happens, use the Philips special setup IR remote to set the A/CH A/V SWITCH menu selection
to OFF.
On-Screen Setup Menus
The remaining installation steps use the IR remote and the TV’s built-in character generator.
1.
Touch Menu, then 999, then Enter.
2.
The text CR MENU> should appear on the screen.
3.
Key in one of the commands shown below, then press Enter to activate.
4.
Note that, in Menu mode, the Channel Down key acts as a backspace/delete key and Channel Up
can act as an Enter.
Command Function
All
The following commands are used for all units
45678
Display firmware version
45679
Display the unit’s Device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with the remote’s numeric keypad, then hit Enter
to save the new number.
65478
Reset unit, similar to disconnecting power then restarting.
65479
Disable smart port communication. After about 5 seconds the TV will drop
communication with the TV controller and revert to stand alone TV mode. At this
point, the installer can switch to the TV Mode on the remote control, and then adjust
the TV setup parameters. To re-enable smart port, press Record on IC-RC.
65487
Initialize to factory default settings: Power on, unlocked, display channel 11, channel
ring set to 4, 5, and 11, Group 0. Note that this command works even if TV power is
off or control is locked out.
65482 Shows
Net RX if receiving the iC-HE’s “heartbeat” pulse once per second, !NET RX
if not. Also displays receive signal strength for ICC2 units.
ICC2
The following commands are used for the ICC2 only
65480
Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the ICC2 unit’s RF output. Press Enter to stop transmitting, or the unit
will automatically stop after 50 seconds.
65481
Display ICC2 transmitter frequency control voltage – should be 2000 - 3150.
65483
Display DF transmitter frequency deviation – should be 245 - 300.