Contemporary Controls CTRLink EIAR-10T, User Manual, Page: 32 / 78

Configuration
4-30
Thereafter, you will be prompted to enter your user name and your
password (default: user: admin, pass: ctr).
The welcoming text of the embedded web server will appear. Now you
can proceed with Section 4.3.1 .
4.2.4 Configuring via the RS 232 interface
It is not recommended to use this type of configuration. It should
only be used if you are absolutely conversant with the handling
and programming of program commands in the terminal mode.
Incorrect inputs or typing errors may result in the router no longer
functioning.
If the router is configured incorrectly and no longer boots
correctly, it is possible to restore the original default settings. To
do so, press ENTER after you have been prompted to do so (on
the console) while the router is booting. In this case, however, all
settings you have made will be lost!
If you wish to configure the router using a browser, it is imperative that
the router is installed in the same network with a network address not
yet used. The default setting of the IP address is 192.168.1.100 with
subnet mask 255.255.255.0. If you do not wish to set the IP address
according to the local network, you can also set the IP address and the
subnet mask via the serial interface to allow access via the network
using a browser (see Section 4.1.1.1).
CAUTION