Contec VPC-3000, User Manual, Page: 92 / 125

7
．
Software RAID setup
User’s Manual
85
7
．
Software RAID setup
. This chapter describes software mirroring (RAID1) setup. We only support mirroring.
CONTEC only supports RAID1. Operations of all other RAID configurations (RAID0, RAID5, RAID10)
are not supported.
Be aware that functions not supported are outside the scope of the warranty.
If RAID settings are changed, all data on the hard disks will be erased.
Back up necessary data in advance.
Starting the setup screen
Before starting the RAID utility, set the AHCI device to RAID in the BIOS setup described
in Chapter 4. Press the <CTRL> and <I> keys on the following screen to start the RAID utility.
After a few seconds, the RAID utility can be started.
Intel(R) Rapid Storage Technology –Option ROM - 12.5.0.1815
Copyright(C) 2003-09 Intel Corporation. All Right Reserved.
RAID Volumes:
ID Name Level Strip Size Status Bootable
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
* *********** ************* ***GB Non-RAID Disk
* *********** ************* ***GB Non-RAID Disk
Press <CTRL-I> to enter Configuration Utility..
Figure 7.1 Setup screen
If the AHCI(or IDE) device is not set to RAID in the BIOS setup, the above screen will not appear.
The above screen does not appear on displays other than that specified for Primary IGFX Boot
Display on the Graphics Configuration setting screen.
CAUTION
CAUTION