Contec VPC-1600, User Manual, Page: 54 / 115

4. BIOS setup
VPC-1600 User’s Manual
47
Administrator Password
1. Select “Administrator Password” on the “Security tab”.
2. “Create New Password” is displayed, so type a password between 3 and 20 characters in length,
and then press the <Enter> key.
3. “Confirm New Password” is displayed, so type the same password that you did in step 2, and then
press the <Enter> key.
User Password
1. Select “User Password” on the “Security” tab.
2. “Create New Password” is displayed, so type a password between 3 and 20 characters in length,
and then press the <Enter> key.
3. “Confirm New Password” is displayed, so type the same password that you did in step 2, and then
press the <Enter> key.
* You cannot set a User Password if an Administrator Password has not been set.
Release of set the password
Although the method for doing this is the same as setting a password, when you enter the password,
press the <Enter> key without entering anything, and the password will be removed. Removing the
Administrator Password and the user password works the same way.
Changing to the device boot order
It is possible to change device boot order.
Boot Option #1
Boot Option #2 [CD/DVD: HL-DT-ST DVDRA ATAPI]
[Hard Disk: WDC WD2503ABYZ (251.0GB)]
Figure 4.4 Changing to the device boot order
1. Select “FIXED BOOT ORDER Priorities” menu from “Boot” tab.
2. Change the settings for “Boot Option #1”, “Boot Otpion #2”, and etc.
3. In order to assign top priority to booting from the CD-ROM, move the cursor to the “Boot Option
#1” item and change the setting to “CD/DVD:…”. (Confirm your choice and setting by pressing
the <Enter> key.)
4. After setting the desired order, press the <Esc> key and move to “Exit” tab.
5. Save setup changes with “Save Changes and reset” and exit.