2. Setup
16
FXA3000 Series
Using magnets for installation
Attach the included magnets to the two magnet
attachment locations on the back of the access point. To
attach the magnets, push them in the direction of the
arrow to insert them entirely into the attachment holes.
- Do not place the magnets near items that are
susceptible to magnetic fields.
- If the product is moved while attached to a steel
desk or other object, it may damage the painted
surface.
Figure 2.9. Using magnets for installation
Using the included screws for
installation
Referring to the diagram to the right, drive the two
included screws into a sturdy, vertical wall surface while
leaving around 3 mm of the screws sticking out from the
wall surface.
Hook the attachment holes on the back of the access
point to the heads of the screws to attach it.
Due to the characteristics of wireless networks, the
signal will spread in a wider area when the access point
is installed in a highly-visible location, so we
recommend you install it in a location as high as
possible.
Note that the placing the product near metal or concrete
walls (including steel beams) may cause the signal
quality to degrade.
- The access point cannot be installed on the ceiling
using the screws due to the danger of falling. If a
ceiling installation is required, use the optional
installation bracket.
- Caution: If the product's ventilation holes are
blocked, the product may malfunction due to a rise
in internal temperature.
Figure 2.10. Using the included screws for
Installation
CAUTION
CAUTION
[mm]
80
±
0.2