Contec DS-380D Series, User Manual

Page: 29 / 69

4. Each Component Function
USB Ports : USB 3.0
This product is equipped with 3 channels for USB 3.0 interface.
You have to configure the BIOS settings to use USB 3.0.
For details on the BIOS settings, see "SB USB Configuration" under "South Bridge" under "Chipset" in
chapter 5.
Table 4.5. USB Connector
Pin
No.
Signal
name
Pin
No.
Signal name
9 SSTX+
1 USB_VCC
8 SSTX-
2 USB-
7 GND
3 USB+
6 SSRX+
4 USB_GND
5 SSRX-
Serial Port Interface : SERIAL
SERIAL (RS-232C port)
This product is equipped with one serial port that complies with RS-232C. This port has a baud rate of
115,200 bps (max.), a dedicated data transmission buffer of 16 bytes, and a dedicated data reception buffer
of 16 bytes. You can use the BIOS setup (see chapter 5) to set the I/O address and interrupt of this port
and to disable the port. (The same I/O address and IRQ cannot be shared with any other device.)
Table 4.6. SERIAL B I/O Addresses and Interrupts
I/O address Interrupt
3F8h - 3FFh IRQ 4
Table 4.7. Serial Port Connector
Connector used on
the product
10-pin RJ-50 (male)
Pin No. Signal
name
Meaning Direction
1 DSR Data set ready Input
2 GND Signal ground -----
3 GND Signal ground -----
4 TXD Transmitted data Output
5 RXD Received data Input
6 DCD Carrier detect Input
7 DTR Data terminal ready Output
8 CTS Clear to send Input
9 RTS Request to send Output
10 RI Ring indicator Input
22
DS-380D Series User’s manual