Contec DIO-32DM3-PE, User Manual

Page: 29 / 63

2. Setup
22
DIO-32DM3-PE
Step 4 Initializing the Software
The driver library requires the initial setting to recognize the execution environment. It is called the
initialization of the Driver library.
This software is initialized automatically during hardware installation. Therefore, if you want to use it
with its initial settings, you can skip the setting procedure described in Step 4. To change the device
name, follow the setting procedure shown below.
Setting the device name
(1) Run Device Manager. From [My Computer] - [Control Panel], select [System] and then select the
[Device Manager] tab.
(You can also open Device Manager by right clicking on My Computer and selecting Properties.)
(2) The installed hardware appears under the CONTEC Devices node. Open the CONTEC Devices
node and select the device you want to setup (the device name should appear highlighted). Click
[Properties].
* The name of the board
you have just added is
displayed.
- DIO-32DM3-PE “DIO000”