Contec BX-951-DC series, User Manual

Page: 89 / 111

5. Each Component Function
82
IPC-BX950T1 / IPC-BX950T2 / IPC-BX950T3
User’s manual
Display Interface : VGA
Connector for display connection is provided. Connector name is VGA(HD-SUB 15P).
When used together with an LVDS interface, it enables dual screen display.
Table 5.8. Display Connector
Connector type
HD-SUB 15 pin (FEMALE)
5 1
11 15
10 6
No.4-40UNC
Inch screw
threads
Pin No. Signal name Pin No. Signal name
1
RED 9 +5V
2
GREEN 10 GND
3
BLUE 11 N.C.
4
N.C. 12 DDCDATA
5
GND 13 HSYNC
6
GND 14 VSYNC
7
GND 15 DDCCLK
8
GND
For the LCDs that can be connected, please refer to “Chapter 7 List of Options”.
Display driver
Install the appropriate audio driver for your OS from the bundled CD-ROM [IPC-SLIB-01].
(For information on the latest version of IPC-SLIB-01, check the CONTEC's web site.)
CAUTION
When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen
mode.
This is because the frequency and resolution of Windows and MS-DOS (full-screen display) are the
same due to the screen settings while the display parameters are different.
For display, as only one parameter can be stored for one frequency or resolution, only either of
Windows or MS-DOS screen can be displayed properly.
In this case, change the resolution or display frequency of Windows so that it is not the same as for
the MS-DOS display.