CONSTRUCTA CA4 14 Series, Instructions For Installation And Use Manual

Page: 28 / 64

28
Changing or cancelling the time
Press the
S
symbol several times until the required
x
indicator lights up. Change the cooking time using
the + or - symbols, or set to
‹‹
.
Notes
■
If a cooking time has been programmed for several plates, it
can be set to display all the time values. To do this, press
the
S
symbol several times until the
x
indicator for the
required hotplate lights up.
■
Any cooking time can be programmed for up to 99 minutes.
Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note:
The cooking time of a plate may be cancelled or
changed:
Press the
S
symbol several times until the required
x
indicator lights up. Change the cooking time using
the + or - symbols, or set to
‹‹
.
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
1.
Press the
S
symbol several times until the
S
indicator lights
up.
‹‹
appears in the time program function display.
2.
Press the
+
or
-
symbol on the time program function. The
basic setting will appear.
+
symbol: 10 minutes.
-
symbol: 5 minutes.
3.
Set the time required using the
+
or
-
symbols.
After a few seconds, the timer will start to count down.
Once the time has elapsed
A warning signal sounds. In the time program function
display
‹‹
is shown, and the
W
indicator comes on. After
10 seconds the indicators turn off.
Pressing the
W
symbol turns off the indicators and stops the
beep.
Changing or cancelling the time
Press the
S
symbol several times until the
S
indicator lights
up. Change the time with the
+
or
-
symbols, or set to
‹‹
.
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
"
symbol. A signal sounds. The control panel is
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note:
The lock does not affect the main switch. The hob may
be switched off when desired.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
”
and
‰
flash alternately.
The indicator goes out when any symbol is pressed.
The hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Basic settings
The device has several basic settings. These settings may be
adapted to the user's individual needs.
Indicator Function
™‚
Childproof lock
‹
Deactivated.*
‚
Activated.
™ƒ
Sound signals
‹
Confirmation beep and error signal deactivated.
‚
Only confirmation beep deactivated.
ƒ
All signals activated.*
*Factory settings
**The maximum power of the hob depends on the configuration of the installation's connection current. To not exceed this maximum
value, the hob includes a series of components that automatically control the power, distributing it between the hotplates in use
as required.