2
Connects2
Vision
www.c2vision-eu.com
CAM-JP2
Extension Cable
Power Adapter
Cable
Make Connections to Vehicle/Unit
Control Unit
Wireless Controller
(Mount on dashboard)
Wiring Diagram
INSTALLATION
Connecting CAN-Bus Wiring
FRONT OF OBD CONNECTOR
FRONT OF OBD CONNECTOR
Locate the vehicle’s OBD port and unscrew/
remove the female connector.
On the reverse of the connector (the side
where wiring enters it), connect the CAN
+ (blue) and CAN - (white) wires from the
harness to the locations specified in the
diagram (Pins 1 and 9).
1
Red
Acc 12V
Connect to vehicle 12V Accessory feed
2
Black
Ground
Connect to source of ground
3
Green
Reverse Output
Connect to aftermarket radio reverse trigger input
4
Purple
Reverse Trigger
Connect to vehicles reverse light for reverse gear trigger
*
5
Blue
CAN +
Connect to rear of OBD connector (see diagram on Page 3)
White
CAN -
Connect to rear of OBD connector (see diagram on Page 3)
* this wire is only needed if you are not using the white/blue CAN data wires.
1
2
3
4
5
6
7
8
10
11
12
13
14
15
16
9
