EasyScopeIII for DS60M10 User Guide
Version 1.3
Document Reference No.: CP_000037 Clearance No.: CP#027
Copyright © Connective Peripherals Pte Ltd
8
Figure 6- Setup Wizard – Installation Complete
2.1.2
Installing the USB Driver
Before using EasyScopeIII the USB driver needs to be installed. This is done by plugging the instrument
into a spare USB port on the PC. The instrument should be plugged into a USB hub port of your PC or
alternatively, a self-powered USB hub (one that has its own power supply).
If this is the first time that the instrument has been plugged in, Windows will request the USB drivers for
your product and will display a Found New Hardware Wizard dialog box. The example below is for
Windows Vista but the procedure is very similar for other Windows versions.
Connect the instrument to a spare USB port on the PC or self-powered hub. The following screen will
appear to begin guiding you through the driver installation.
Figure 7- New Hardware Found UI
Select “Locate and install driver software (recommended)”. Wait for few minutes for the device
driver to be installed. If it’s successful, the following popup will appear."
