EasyScopeIII for DS60M10 User Guide
Version 1.3
Document Reference No.: CP_000037 Clearance No.: CP#027
Copyright © Connective Peripherals Pte Ltd
38
Sample Rate
Sample Rate Unit
Channel Enable buttons
Test mode
Saturation Voltage controls
Track Data Logger
Realtime / Non-realtime display
4.3.2
Stop Button
Clicking the Stop button will halt data capture.
When stopped, a caption appears on the lower left of the plot area which says “Stopped”.
Also, the disabled controls (as stated in "Start Button") will be re-enabled.
4.3.3
Sample Interval
Use the Sample Interval control to specify the logging rate.
This must be set before starting data capture. This will be disabled when data logger is in running mode
and will be re-enabled after stopping.
Any sampling rate may be specified as long as it’s a multiple of 1ms. If an invalid value is specified, it will
be changed to the nearest multiple of 1 ms value. Data points may be missed at fast sampling rate;
these are indicated with a red cross in the plot with a Y value of 0.
