12
Figure 8.
Grounding wiring
2.4 Powering the Managed Industrial Gigabit
Ethernet Switch
The Managed Industrial Gigabit Ethernet Switch can be used with DC power
48-54 VDC with the terminal block. The terminal block is located on the upper
panel of the Managed Industrial Gigabit Ethernet Switch. Before powering the
Managed Industrial Gigabit Ethernet Switch, please make sure that network
cables and power cables are securely connected.
ATTENTION
Before connecting the Managed Industrial Gigabit Ethernet
Switch to the DC power inputs, make sure the DC power
source voltage is stable.
Wiring the terminal blocks
P1 and P2 power supply
are two pairs of contacts on the terminal block for
power redundancy purpose. The redundant power supply will take over
seamlessly when one power source is down to protect your device or network
from the loss of power.
Power Input Configuration
Insert the positive and negative wires into the
“+” and “-” contacts on the
terminal block.
