Rogue-X – NVIDIA® Jetson AGX Xavier™ Carrier
Users Guide
Document: CTIM-00082
Revision: 0.01
Page 34 of 40
Date: 2021-04-14
Push Button Switches
Function
Power/Reset/Force Recovery Buttons
Location S3, S6, S5
Type
Momentary Push button micro switches
Function Power ON switch (S3): a press of >500ms
when in manual mode will trigger system to
power ON.
Reset Switch (S6): a press of >500ms will
trigger a full system Reset.
Force Recovery (S5): No function during
normal operation. Will place the AGX Xavier
Module into Force Recovery Mode when
held during power ON.
TYPICAL INSTALLATION
1.
Ensure all external system power supplies are off.
2.
Install the Jetson AGX Xavier™ Module onto the Molex Mirror Mezz™ Connector. Be sure to
follow the manufacturer’s directions for proper installation of mounting hardware,
heatsink/heatspreader, and any other applicable requirements from the manufacturer.
3.
Install the necessary cables for application. At a minimum these would include:
a)
Power cable to the input power connector on the carrier
b)
HDMI video display cable
c)
Keyboard and mouse via USB
For additional information on the relevant cables, please see the Cables and Interconnects section
of this manual.
4.
Connect the Power Cable to the Power Supply.
5.
Switch ON the Power Supply. DO NOT power up your system by plugging in live power.
SOFTWARE
For L4T (Linux for Tegra) BSPs and Software Support NVIDIA® Jetson™ AGX Xavier™ please follow this
link: https://connecttech.com/resource-center/l4t-board-support-packages/
