Connect Tech GraphiteVPX/GbE, User Manual, Page: 14 / 26

GraphiteVPX/GbE 16+4-Port - Managed Carrier Ethernet Switch
Users Guide
www.connecttech.com
Document: CTIM-00461
Revision: 0.02
Page 14 of 26
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2016/10/27
CLI Basics
Once opening the COM port attached to the management port, after boot up your terminal output should look
like the output below. The
default login is admin and password is blank(“”). So after typing admin hit
<ENTER> then hit <ENTER> again to login and “?” will display a list of the available commands.
Below is a list of common quick CLI commands. For a complete CLI reference please see the documents
described below.
Common Task CLI Command Syntax
Help menu – from any level, add a ‘?’ to the
end of a command for a list of options at that
level.
show ? OR show ip int ?
What are the IP addresses used by my
switch?
show ip int br
What ports are linked and at what speed?
show int * status
What software version is on my switch?
show ver
How do I save my configuration?
copy running-config startup-config
How do I setup my IP address for vlan1?
conf t
int vlan 1
ip add xxx.xxx.xxx.xxx 255.255.255.0
end
Complete CLI and Protocol Configuration Reference Guide
The complete CLI and Protocol Configuration reference guide from Microsemi for the VSC7429 device can be
downloaded here .
The following documents:
- AN1104-Software_Configuration_Guide_ICLI
- AN1115Layer2ProtocolConfigurationGuide
Will have the below mentioned copyright notice.
Copyright 2002-2015 Microsemi Corporation. All Rights Reserved. Unpublished rights reserved under the
copyright laws of the United States of America, other countries and international treaties. Microsemi retains
all ownership, copyright, trade secret and proprietary rights in the documentation.