77
6.6
SALT FILLING
The water softener operates automatically. For each regeneration, approx. 200 g of salt is used. The regen-
eration salt has to be filled up regularly.
6.6.1
MESSAGE “VERIFY SALT LEVEL”
Usually, regeneration salt is filled up using 25 kg sacks. This amount of salt provides at least 100 regener-
ations. After 100 regenerations, the display indicates:
After this message, fill up with 25 kg of regeneration salt. Then press the <OK> key briefly. This will reset
the warning message.
If regeneration salt has already been filled up before the display indicates it is necessary to do so, the salt
quantity regeneration counter can be reset by pressing <OK> and within 3 seconds at the same time
.
The display will then show the following message:
After 5 seconds, the operating mode comes up on the display.
6.6.2
MESSAGE IN CASE OF INSUFFICIENT SALT
The salt concentration of the brine is checked during each regeneration. If the salt container is not topped
up in time and the brine concentration is too low, the display indicates:
After this message, fill with 25 kg of regeneration salt. Then press the <OK> key briefly. This will reset the
warning message.
Our recommendation:
High-grade regeneration salt in tablet form (KBN: SALZT).
Salt level
verify!
Salt level count
was reset
Attention!
Salt deficit
Summary of Contents for CLEAR SOFT TWIN
