60
5.3
INSTALLATION POSITION
5.4
ELECTRICITY SUPPLY
The mains voltage may not be interrupted (e.g. by light switches)!
If the water softener is not permanently supplied with power,
/
no regeneration takes place,
/
no alarm is given in case of faults,
/
water losses or even water damage can occur, if there is an interruption during regeneration.
5.5
MOUNTING THE BUILT-IN ROTARY FLANGE
Install using the supplied built-in rotary flange. The built-in rotary flange is used as a connecting element
between the pipe and the water softener. It is suitable for both horizontal and vertical pipes. The installa-
tion height depends on the pipe layout. The minimum installation height from the floor to the rotary flange
is 52 cm.
The built-in rotary flange must be installed in the direction of flow. This is marked by a
cast in arrow (see fig. 3).
Always install the water softener in a vertical position (± 5°)! Failure to observe
this can impair its function.
A splash proof socket is required for the power supply, in accordance with the le-
gal regulations for wet rooms!
Fig. 3: Built-in rotary flange
Profiled flange gasket
Flow direction arrow
Summary of Contents for CLEAR SOFT TWIN
