Operating Instructions
Single-pole Conductor Rail System
SingleFlexLine Program 0815
BAL0815-0002g-US
www.conductix.us
translated document
page 42 of 128
6.3.2.3
Making a bend in the conductor rail
Read and observe the additional operating instructions!
You can find additional information on the making a bend in a conductor rail in BAL0800-0004.
Conductor rail bends can be fabricated in the factory or on site. They are prepared using the bending device 081091. For large
installations, electrically driven bending devices are available on request.
Fig. 28: Outer/inner bends and horizontal bend
Use of bends in horizontal and vertical curves
Insertion direction of the current collector
Vertical (from below)
Horizontal (from the side)
Horizontal curve
Horizontal bend
Suspension distance: 400 mm
Bend radius: 1000 mm to ∞
Inner/outer bend
Suspension distance: 250 mm
Bend radius: 450 mm to ∞
Vertical curve
Inner/outer bend
Suspension distance: 250 mm
Bend radius: 450 mm to ∞
Horizontal bend
Suspension distance: 400 mm
Bend radius: 1000 mm to ∞
Pos.
Name
1
Inner bend
2
Outer bend
3
Horizontal bend
