1
CONDOR ® UBS-2000 ULTIMATE BIKE STAND USER INSTRUCTION MANUAL
STOP! WARNING: READ THIS FIRST!
First read and understand the instruction manual and product labels for important safety, set-up and troubleshooting
information. If you have problems setting up or using the UBS-2000 Ultimate Bike Stand by Condor
® , contact
customer service at (815) 754-7418 or contact us via email @
www.condor-lift.com
. The UBS-2000 Ultimate Bike
Stand by Condor
® is not intended for use by children.
Instructions:
1.
Remove the UBS-2000 from packaging and place the unit on the ground in front of motorcycle with the
pivot lifting arm on the left front side of the unit as shown in Figure 1.
2.
Roll the bike forward over the unit until the rear tire is positioned on the back of the base plate as shown in
Figure 2.
3.
Hold the bike securely upright with your left hand on the handlebar and your right hand on the rear of the
bike from a secure location. Raise the side lever from the lower position to the upper position using your
right foot as shown in Figure 3 and Figure 4. Continue holding the bike steady while pushing back and
down on the foot lever to raise the platform up to the underside of the motorcycle’s frame as shown in
Figure 5.
Note: It might take several attempts to become familiar with the optimal location of the motorcycle
with respect to the unit prior to lifting the bike off the ground.
4.
Once the platform is firmly pressed against the underside of the bike, double check (while making sure that
the bike is held securely upright) that the bike is centered and properly positioned in middle of the raising
platform. While continuing to hold the bike securely upright, push the foot lever back and down while
pulling back and guiding the bike into the upright position as shown in Figure 6.
5.
Once the bike has been raised with the lever positioned back and down to the ground, locate the quick
release pin attached to the unit as shown in Figure 7. Secure the unit in its upright position by inserting the
pin into the hole as shown in Figure 8.
6.
To lower the motorcycle off of the stand, first remove the pin shown in Figure 8. Take hold of both handle
bars and simply push the motorcycle forward. The stand will collapse and the bike will be able to roll
forward over the unit.
