Concoa Advantium 1 Plus, Installation And Operating Instructions Manual, Page: 14 / 20

11
MUTING AUDIBLE ALARM
It is sometimes desirable to silence the audible alarm on the Advantium 1 Plus . This can
be accomplished by turning OFF the audible alarm switch inside the alarm. FACTORY
DEFAULT IS ON. To turn OFF the audible alarm perform the following steps:
1. Turn AC power switch OFF and unplug the alarm from AC power .
2. If the alarm is anchored to a wall remove the four screws holding it to the wall
to gain access to the back of the unit
.
3. Separate the front and back of the unit by loosening the 4 screws located on
the rear of the enclosure
.
4. Using Figure 9 locate SW2 switch 3 and turn it OFF.
5. Replace back cover using the previously removed screws.
6. Re-attach the alarm to the wall using the previously removed screws.
7. Plug the alarm back into AC power.
8. Turn alarm ON by turn the power switch on the bottom of the alarm to the ON
position.
9. Test unit.
ENABLING ALARM DELAY FUNCTION
The Advantium 1 Plus has a built in alarm delay feature. This feature, when set, will
delay both the visual and audible alarm signals for a period of 40 minutes. The
Advantium 1
Plus alarm is shipped from the factory with the Alarm Delay feature shut
OFF. If you wish to enable this alarm delay feature perform the following steps:
1. Turn AC power switch OFF and unplug the alarm from AC power .
2. If the alarm is anchored to a wall remove the four screws holding it to the wall
to gain access to the back of the unit
.
3. Separate the front and back of the unit by loosening the 4 screws located on
the rear of the enclosure
.
4. Using Figure 9 locate SW2 switch 1 and turn it ON.
5. Replace back cover using the previously removed screws.
6. Re-attach the alarm to the wall using the previously removed screws.
7. Plug the alarm back into AC power.
8. Turn alarm ON by turn the power switch on the bottom of the alarm to the ON
position.
9. Test unit.