68
69
EN
EN
SC2500
SC2500
HOW TO RIDE THE ELECTRIC SCOOTER
1. Press and hold the On/Off button for 2 seconds.
2. Place one foot on the deck and use the other one to kick off the ground.
3. After you reach a sufficient speed and you feel stable, place your other foot on the deck of the electric scooter.
4. After start, slightly press the accelerator and carefully turn the handlebars to change direction.
5. Press the ACCELERATOR button to accelerate. Be careful and do not ride too fast!
6. Press the brake lever and lightly step on the rear brake to brake.
7. When the electric scooter slows down enough, remove your foot from the deck. After the electric scooter stops
completely, put both your feet on the ground.
RANGE OF THE ELECTRIC SCOOTER
The range of the electric scooter can be affected by several factors, such as the weather, weight, battery charge and state
of the road. These are just main examples, each factor can affect the range and many of them can combine with each
other. Please bear in mind that the total range given in specifications is for reference only. The actual range can vary
greatly. Bear it in mind when using the electric scooter.
Scooter range depending on weight
Range in k
m
Weight in kg
BATTERY SPECIFICATIONS
Follow these storage and charge instructions to extend battery lifespan and performance. Please pay special attention
to safety precautions and other specifications.
Battery specifications
Type
Li-ion battery
Charging time
3-4 hours
Voltage
36 V
Operating temperature
0-35 °C
Charge temperature
0-35 °C
Storage temperature
-8 °C – 35 °C
Maximum charging voltage
42 V
Recommended storage time (-8 °C – 35 °C)
3 months when fully charged
Battery capacity
6.4 Ah
OPERATING INSTRUCTIONS
ELECTRIC SCOOTER ASSEMBLY
Warning
Always switch off the electric scooter and disconnect the charger from wall socket before assembling or removing accessories!
1. Pull the column under
t h e h a n d l e b a r s a n d
simultaneously press on the
mudguard of the rear wheel.
2. Put the column upright and
use the locking ring to secure
the safety lock.
3. Secure the brake lever with
an M5 Allen key.
4. Tighten the handlebars
(pay attention to the direction
when tightening).
5. Tighten the bolt at the
column so that it is stationary.
ELECTRIC SCOOTER ASSEMBLY
1. Loosen the locking ring.
2. Loosen the safety lock.
3. Lower the column.
4. The hook must fit into
the opening on the rear
mudguard, press to secure it.
Summary of Contents for SC2500
Page 82: ......
