EN
26
OPK2160
b) Carbon filters (must be purchased)
These filters are used only in the re-circulation mode.
The filters contain active carbon that absorbs the ventilated odors. After a while the active carbon is saturated, and
loses its absorption ability. These filters can‘t be washed or otherwise cleaned.
Under normal use, the carbon filters should be replaced every 2 months. In case of more frequent frying or deep
frying, shorten the interval.
1. Remove the metal filters (Fig. 1), and remove the carbon filters from them.
2. Mount new carbon filters on the metal ones (Fig. 2), and put the set back.
Fig. 2
UNIT INSTALLATION
• Only authorized personnel can install the power connection!
• Only the customer is responsible for installation in situ. Defects caused by incorrect
installation are not covered by the warranty.
• Remove all the covering and marketing materials from the unit before the first use.
• We recommend that you let a specialized company perform the installation.
• The manufacturer bears no responsibility for damage caused to people, animals or
objects as a result of incorrect installation.
Follow the installation instructions:
1. Remove both fat (or carbon) filters.
2. Select one of the three output holes for the airing mode. Unused holes shall be
covered by the supplied casings so as not to reduce the performance of the unit.
For the re-circulation mode, close all the four output holes.
3. Put the unit on the lower edge of the upper cupboard of the kitchen set. Check the
minimum required height according to Fig. 3 (650 mm for electric, and 750 mm for
gas hotplates).
4. You will see the fixing holes through the lower orifice of the unit. Mark the positions
on the wall and bottom side of the cupboard.
5. Mark the position and diameter of the hole for output piping.
6. Drill the fixing holes in the wall, possibly also for the output piping.
7. Fix the unit to the wall using the wall plugs and screws (Fig. 4).
Fig. 3
