IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic
safety precautions should always be followed
to reduce risk of fire, electric shock and injury
to persons including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions
marked on the product.
3. Unplug this product from the wall outlet
before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for
cleaning.
4. Do not use this product near water, for
example, near a bath tub, wash bowl,
kitchen sink, or laundry tub, in a wet
basement or near a swimming pool.
5. Do not place this product on an unstable cart,
stand, or table. The product may fall causing
serious damage to the product.
6. Slots and opening in the cabinet and back or
bottom are provided for ventilation, to protect
from overheating. These openings must not
be blocked by placing the product on the bed,
sofa, rug, or other similar surface. This
product should not be placed in a built-in
installation unless proper ventilation is
provided.
7. Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points or short out
parts that could result in a risk of fire or
electric shock. Never spill liquid of any kind
on the product.
8. To reduce the risk of electric shock, do not
disassemble this product, but take it to a
qualified serviceman when some service or
repair is required. Opening or removing covers
may expose you to dangerous voltages or
other risks. Incorrect reassembly can cause
electric shock when the appliance is
subsequently used.
9. Unplug this product from the wall outlet and
refer servicing to qualified service personnel
under any of the following conditions:
A. When the power cord or plug is damaged or
frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or
water.
D. If the product does not operate normally by
following the operating instructions. Adjust
only those controls that are covered by the
operating instructions because improper
adjustment of other controls may result in
damage and will often require extensive work
by a qualified technician to restore the
product to normal operation.
E. If the product has been dropped or the
cabinet has been damaged.
F. If the product exhibits a distinct change in
performance.
10. Avoid using a telephone (other than a
cordless type) during an electrical storm.
There may be a remote risk of electric shock
from lightning.
11. Do not use the telephone to report a gas
leak in the vicinity of a leak.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1. Never install telephone wiring during a
lightning storm.
2. Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
3. Never touch uninsulated telephone wires
or terminals unless the telephone line
has been disconnected at the network
interface.
4. Use caution when installing or modifying
telephone lines.
NOTE: Refer to “FCC Requirements”
section before connection to telephone
line.
LOCATION OF CONTROLS
PREPARATION
In addition to the handset and telephone
base, each carton contains the following
accessories:
• One (1) 6 ft. fully modular telephone line cord
(long, straight cord)
• One (1) 7 ft. fully modular coil cord
• Owner’s Manual/Warranty Card
Diagram A
Important Notice
Your CONAIRPHONE
TM
telephone will operate
on all systems, true tone or rotary.
1. If your home is wired for rotary service,
move switch to pulse position (P).
2. If your home is wired for tone service, move
switch to tone position (T).
3. If you are unsure of the type of service you
have, ask your local telephone company.
1
2
3
4