Instruction manual bike
LED battery light set
DLUX micro 40
Scope of delivery
Assembly / disassembly
Operation
Alignment
Proper use
The product is intended for use on bicycles with pedal assistance and serves the illumination of the road.
This LED front light is approved according to the currently valid RTLR (StVZO). The product is intended for
outdoor use.
Safety instructions
- Do not look into the light.
- Do not point the light directly at people or animals.
- The light beam of the LED front light must point straight in direction and may not blind other road users.
- The light distribution may be obscured by no other attached parts or pieces of luggage, not even partially.
- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be replaced.
WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!
Never leave children unattended with the packaging material, because of suffocation danger by
swallowing packaging parts. Always keep the device away from children. The device is not a toy! This
device can be used by children of age 8 and over and by persons with reduced physical or mental
capabilities or lack of experience and knowledge if they have been supervised or instructed concerning
the safe use of the device and by understanding resulting hazards. Children are not allowed to play with
the device. Cleaning and user maintenance should not be carried out by children without supervision.
Do not disassemble the device. Improper repairs can cause significant risks for the user. Only have
repairing made by qualified personnel.
•
battery front light
adapter cable USB-C to USB-A
adapter cable micro-USB to USB-A
•
handlebar bracket
•
insert for Ø 25-30mm
•
insert for Ø 30-35mm
•
battery rear light
•
mounting clip
•
rubber straps
Manual
_DLUX micro 40
General notes
Switch on/off
asseembly
disassembly
Centering
Inclination
micro-USB socket
Handlebar bracket
Preparation: select suitable insert (Ø 25-30mm or Ø 30-35mm)
on the basis of the given handlebar size and insert into the
handlebar clamp
Place clamp around handlebar and hook in grip nut
Tighten the handle nut
Front Lights
1.
1.
2.
2.
1. Put on the front headlight on rear edge of bracket
2. Press down until the front headlight engages in
the clamp bracket
1. Press release button on underside and
remove front headlamp (2.)
To switch on and off, press and hold the button for 2 seconds each time.
Brightness levels
The front headlight has 4 selectable brightness level. The activation of the next brighter
level is achieved by a short push of the button.The highest brightness level is followed
by the lowest brightness level again.
Brightness levels indicator
2
1
Brightness levels
The two brightness levels are indicated by different colored lights of the LED ring.
Low battery mode
From a remaining battery capacity of 4%, the front headlight limits the brightness to level 1. The
lowest LED of the battery status indicator flashes red.
Temperature monitoring
If the lamp head overheats, the front light limits the brightness to level 1 until the normal operating
temperature is reached again.
Charging
The internal battery of the rear light is charged by a USB voltage source. The supplied adapter cable is
plugged into the micro-USB socket on the bottom of the rear light.
Attention
!
Check regularly the correct setting of your front light.
Align the LED front light so that the light beam reaches the road approx. 10 meters in front of the wheel (see ill.). The
light beam of the LED front light must point straight in direction from 400 up to 1200mm.
