DeviceMaster LT User Guide
: 2000586
Rev. B
RedBoot Procedures - 101
Establishing a Telnet Connection
Establishing a Telnet Connection
Use the following procedure to telnet to the DeviceMaster LT.
1.
Open a telnet session, enter the DeviceMaster LT IP address. If using
Windows, open a
Command
window and type
telnet
[
ip_address
]
2.
Press the
Enter
key if you did not program a password or type the password
and press
Enter
.
Note:
The DeviceMaster LT does not come pre-programmed with a password.
3.
Type
reset
, and close the session.
4.
Open a new telnet session, enter the DeviceMaster LT IP address, and the
password.
5.
Type
dis
to disable the Bootloader.
6.
Verify that the system responds with a
Loading disabled
message.
♥♦
Password:
Comtrol DeviceMaster RTS Model ID: 5002535
SocketServer 9.18
Built: Wed Aug 28 11:08:48 CST 2013
IP Addr: 192.168.11.52, Mask: 255.255.0.0, Gateway: 192.168.0.254
MAC Addr: 00:c0:4e:29:ff:f5
dm> reset
*********************************************
**
** Comtrol DeviceMaster Bootloader Version 3.23
** RedBoot(tm) environment - built 14:59:20, Oct 13 2011
** Platform: Comtrol DeviceMaster (ARM 7TDMI)
** Portions Copyright (C) 2000. Red Hat, Inc.
** Portions Copyright (C) 2001-2008 Comtrol Corp.
*********************************************
FLASH: 64 blocks of 65536 bytes each
FLASH: 4194304 bytes (0x05000000 - 0x05400000)
RAM: 8126464 bytes (0x00000000 - 0x007c0000)
RedBoot>
dis
Loading disabled
RedBoot> _
