Comtrol 99531-9, User Manual, Page: 141 / 160

DeviceMaster PNIO | UP User Guide : 2000639 Rev. A RedBoot Procedures - 141
RedBoot Procedures
Establishing a Telnet Connection
Use the following procedure to telnet to the DeviceMaster.
1. Open a telnet session, enter the DeviceMaster IP address.
If using Windows, you can use PortVision DX, see Accessing RedBoot
Commands in Telnet/SSH Sessions (PortVision DX) on Page 135.
2. Press the
Enter
key if you did not program a password or type the password
and press
Enter
.
Note: The DeviceMaster does not come pre-programmed with a password.
3. Type reset , and close the session.
4. Open a new telnet session, enter the DeviceMaster IP address, and the
password.
5. Type dis to disable the Bootloader.
6. Verify that the system responds with a
Loading disabled
message.