IP Address:
Enter the IP address for the LAN port.
Subnet Mask:
Enter the subnet mask for the LAN port.
Enable UPnP:
Tick the box to enable Universal Plug and Play.
This option is hidden when NAT disabled or if no PVC exists
Enable IGMP Snooping:
Enable by ticking the checkbox.
DHCP Server:
To enable DHCP, select
Enable DHCP server
and enter
starting and ending IP addresses and the leased time. This
setting configures the router to automatically assign IP,
default gateway and DNS server addresses to every PC on
your LAN.
DHCP Server Relay:
Enable with checkbox and enter DHCP Server IP address.
This allows the Router to relay the DHCP packets to the
remote DHCP server. The remote DHCP server will provide
the IP address.
This option is hidden if NAT is enabled
Configure the second IP address
by
ticking the checkbox shown below.
IP Address: Enter the secondary IP address for the LAN port.
Subnet Mask: Enter the secondary subnet mask for the LAN port.
NOTE:
The
Save
button saves new settings to allow continued configuration
while the
Save/Reboot
button not only saves new settings but also
reboots the device to apply the new configuration (i.e. all new settings).
6.3 NAT
To display this option, NAT must be enabled in at least one PVC shown on the
screen. (
NAT is not an available option in Bridge mode
)
48
Summary of Contents for CT-5611E
Page 1: ...CT 5611E ADSL2 Combo Router for Annex B User Manual Version A1 0 June 2 2008 261070 009...
Page 14: ...13...
Page 41: ...40...
