Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 257 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–63 MN-SLM-5650A
10.3.11 TRANSEC Module Interface Commands and Queries
The instruction codes that follow are valid only when the optional TRANSEC Module is installed in the SLM-5650A Satellite Modem.
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
TRANSEC
Ethernet
Interface
Gateway IP
Address
SMG= SMG? 15 bytes Command or Query.
Set or return the Gateway IP Address for the TRANSEC Module in
the form aaa.bbb.ccc.ddd, where:
aaa.bbb.ccc.ddd = Gateway IP Address
Example: <0001/SMG=010.006.030.001{CR}
N/A SMG=aaa.bbb.ccc.dd
d
TRANSEC
Ethernet
Interface
Management IP
Address and
Subnet Mask
SMI= SMI? 18 bytes Command or Query.
Sets or returns the Management IP Address and Subnet Mask for the
TRANSEC Module in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = Management IP Address, and
ee = Subnet Mask (0-31)
Example: <0001/SMI=010.006.030.001.24{CR}
N/A SMI=aaa.bbb.ccc.ddd.
ee