Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 255 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–61 MN-SLM-5650A
10.3.10 Network Processor (NP) Interface Commands and Queries
The instruction codes that follow are valid only when the optional Network Processor (NP) Interface Module is installed in the SLM-5650A
Satellite Modem.
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Router BPM
Mode
BRT= BRT? 1 byte Command or Query.
Sets or returns the NP Module’s BPM (Bridge Point-to-Multipoint)
mode in the form a, where:
0 = Off
1 = On
Example: <0001/BRT=0{CR}
NOTE: Changing the Bridge Mode will leave QOS On. QOS should
be turned Off prior to setting the Bridge Mode.
BRT=
BRT?
BRT*
BRT#
BRT=a
Router Working
Mode
GBM= GBM? 1 byte Command or Query.
Sets or returns the NP Module Router Working Mode in the form a,
where:
1 = Vipersat Hub
2 = Vipersat Hub Expansion
3 = Vipersat Remote
4 = Vipersat Remote Expansion
5 = Multipoint Hub
6 = Multipoint Remote
7 = Point to Point
8 = GigaBit Bridge
Example: <0001/GBM=7{CR}
GBM=
GBM?
GBM*
GBM#
GBM=a
Router Ethernet
Interface
Management IP
Address and
Subnet Mask
MIP= MIP? 18 bytes Command or Query.
Sets or returns the Management IP Address and Subnet Mask for the
NP Module in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = IP Address, and
ee = Subnet Mask (0-31)
Example: <0001/MIP=010.006.030.001.24{CR}
MIP=
MIP?
MIP*
MIP#
MIP=aaa.bbb.ccc.ddd.
ee