Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 249 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–55 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Clear All AUPC
Log Entries
CAA= N/A None Command only.
Forces the firmware to clear the firmware AUPC log.
Note: This command takes no arguments.
CAA=
CAA?
CAA*
CAA#
N/A
Initialize AUPC
Log Pointer
IAP= N/A None Command only.
Resets internal pointer to allow RNA? queries to start at the beginning
of the stored statistics log.
Note: This command takes no arguments.
IAP=
IAP#
N/A
AUPC Local
Carrier Loss
Action
LCL= LCL? 1 byte Command or Query.
Sets or returns Tx Output Power level setting when local carrier is lost
in the form x, where:
0 = Hold current output power level
1 = Goto Nominal output power level
2 = Goto Maximum output power level
Example: <0001/LCL=0{CR}
LCL=
LCL?
LCL*
LCL#
LCL=x
AUPC Local
Enable
LPC= LPC? 1 byte Command or Query.
Sets or returns Local AUPC Control in the form x, where:
0 = Off
1 = On
Note: When Local AUPC Control is enabled, modulator output power
is automatically controlled by the modem. Power output commands
via TPL are not allowed during this mode; although, queries will
function as normal.
Example: <0001/LPC=1{CR} (Turns on Local AUPC Control)
LPC=
LPC?
LPC*
LPC#
LPC=x
Number of
Unread AUPC
Log Entries
N/A NUA? 3 bytes Query only.
Returns the Number of AUPC Log Entries that remain Unread over
the serial remote interface, in the form xxx.
Example: >0001/NUS=126{CR}{LF}
N/A NUA=xxx