Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 226 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–32 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
CnC-APC State
(cont)
11 = OK(Partial) – Distant power approaches limit set by max
power level increase
12 = OK(Partial) – Incomplete
13 = No APC Frame Sync
14 = CnC Ratio Problem
15 = Local Eb/No too high
16 = Distant Eb/No too high
17 = Distant End ReBalance failed
18 = Distant End No Response
19 = Fail-Calculate Mismatch
20 = CnC Ratio too high
21 = Please run again
22 = APC is active
23 = Local margin too low
24 = Distant margin too low
25 = Rx Data Rate < 64 kbps
26 = Tx Data Rate < 64 kbps
27 = Local RSL too low
28 = Distant RSL too low
29 = Unrecognized Modem
Example: >0001/APS=00{CR}{LF}
Buffer Fill State N/A BFS? 2 bytes Query only.
Returns the value of the buffer fill state in the form xx, where:
xx = value from 1 to 99%
Note: Returns 00 if demodulator is unlocked.
Example: >0001/BFS=33{CR}{LF} (reports 33%)
N/A BFS=xx
Clear All Stored
Events
CAE= N/A None Command only.
Forces the firmware to clear the Stored Events log.
Note: This command takes no arguments.
CAE=
CAE?
CAE*
CAE#
N/A