Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 216 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–22 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Rx Data Rate RDR= RDR? 10 bytes Command or Query.
Sets or returns the Rx Data rate, in the form xxxxxx.xxx where:
xxxxxx.xxx = Rx Data rate, in kbps, in 1 bps steps.
Example: <0001/RDR=002047.999{CR} (selects 2047.999 kbps)
N/A RDR=xxxxxx.xxx
Rx BERT BER N/A BBR? 6 bytes Query only.
Returns the value of the Rx BERT BER in the form a.bEcc where:
a.b = BER value
Ecc = Exponent
Note: Returns 0.0E00 if the BERT is not synchronized to a pattern.
Example: >0001/BBR=4.9E12{CR}{LF} (Reports BER as 4.9 x 10
-12
)
N/A BBR=a.bEcc
Rx BER N/A BER? 6 bytes Query only.
Returns the value of the estimated corrected BER in the form a.bEcc
where:
a.b = BER value
Ecc = Exponent
Note: Returns 99999 if the demodulator is unlocked.
Example: >0001/BER=4.8E03{CR}{LF} (reports BER as 4.8 x 10
-3
)
N/A BER=a.bEcc
Rx BERT Reset BRS= N/A None Command only.
Resets the Rx BERT.
Note: This command takes no arguments.
BRS=
BRS?
BRS*
BRS#
N/A
Rx BERT State BRX= BRX? 1 byte Command or Query.
Sets or returns the Rx BERT State in the form x, where:
0 = Off
1 = On
Example: <0001/BRX=1{CR} (sets Rx BERT as ON)
BRX=
BRX?
BRX*
BRX#
BRX=x