Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 210 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–16 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Tx Data Fault TDF= TDF? 1 byte Command or Query.
Sets or returns the Transmit Data Fault in the form x, where:
0=None
1=DATA
2=AIS
Example: <0001/TDF=0{CR} (selects Data Fault = None)
TDF =
TDF?
TDF*
TDF#
TDF=x
Tx Data Invert TDI= TDI? 1 byte Command or Query.
Sets or returns the Invert Transmit Data in the form x, where:
0=Normal
1=Inverted
Example: <0001/TDI=1{CR} (selects Inverted TX Data)
TDI =
TDI?
TDI*
TDI#
TDI=x
Tx Frequency TFQ= TFQ? 9 bytes Command or Query.
Sets or returns the Tx Frequency in the form xxxx.xxxx, where:
xxxx.xxxx = frequency value, in MHz, in 100 Hz steps.
Note: Where 70/140 MHz operating range is from 52 to 88 MHz or
104 to 176 MHz, and L-Band operating range is from 950 to 2000
MHz.
Example: <0001/TFQ=0140.9872{CR}
TFQ=
TFQ?
TFQ*
TFQ#
TFQ=xxxx.xxxx
Tx Power Level TPL= TPL? 5 bytes Command or Query.
Sets or returns the Tx Output power level, where:
s = sign (+/–)
xx.x = Tx Output power level value where the range is from –40.0
to +10.0 dBm.
Example: <0001/TPL=–13.4{CR}
TPL=
TPL?
TPL*
TPL#
TPL=sxx.x