LBC-4000 L-Band Up/Down Converter System
Revision 6
Front Panel Operation
6–10
MN-LBC-4000
6.3.3.2.1
(REMOTE:) Local
Remote Mode: press ENT
for local mode, or CLR
Press
[ENT]
to switch to Local Mode to continue with your task, or press
[CLR]
to exit the task
and remain in the active mode.
1.
When you select Local mode, remote monitoring is possible, but
remote control is disabled.
2.
A number of operations are possible in Local mode only. If you are in
Serial or Ethernet mode during such tasks, the unit alerts you to this
remote state.
6.3.3.2.2
(REMOTE:) SERIAL
Serial Mode = RS-232
Addr=001 Baud=9600 8-N-1
On the top line, use the
[
][
]
arrow keys to set the mode to
RS-232
or
RS-485
.
On the bottom line, set the Serial address (
Addr
). Use the
[
][
]
arrow keys to select a digit,
and then the
[
][
]
arrow keys to change its value. The valid range of addresses is from
001
(default) to
255
.
Next, set the
Baud
rate. Use the
[
][
]
arrow keys to select the parameter, and then the
[
][
]
arrow keys to select the desired baud rate of
1200
,
2400
,
4800
,
9600
(default),
19K2
, and
38K4
.
Finally, set the asynchronous character format. Use the
[
][
]
arrow keys to select the parameter,
and then the
[
][
]
arrow keys to select the desired format (i.e., number of data bits; odd, even,
or no parity; number of stop bits) as
8-N-1
,
7-E-2
, or
7-O-2
.
Press
[ENT]
.
6.3.3.2.3
(REMOTE:) ETHERNET
The LBC-4000/-ST L-Band Up/Down Converter System, as initially released,
does not feature a rear panel ‘10/100 ETHERNET’ port. Only current production
units offer Ethernet Interface operation. See Chapter 4. REAR PANEL
CONNECTORS for more information.
ADDRESS GATEWAY SNMP
MAC = 00-06-B0-00-00-0F
On the top line, use
the
[
][
]
arrow keys
to select
ADDRESS
,
GATEWAY
, or
SNMP
. (The
bottom line displays the
read-only
unit MAC address.) Press
[ENT]
.
