LBC-4000 L-Band Up/Down Converter System
Revision 6
Firmware Update
5–5
MN-LBC-4000
5.2.3.2
HTTP Interface Used for Firmware Information
Chapter 7. ETHERNET INTERFACE OPERATION
Do these steps:
1. Go to either of these pages to review the firmware information:
•
The ‘Firmware Information’ section of the ‘Config | Utility’ page provides the
firmware details as Boot, Bulk1, and Bulk2, as shown in this example:
•
The ‘Summary’ section of the ‘Status | Summary’ page provides the firmware
details – “FW Revision”, “Active Software Image”, and “Next Reboot Image” – as
shown in this example:
2. Write down your firmware information for further reference or to provide to Comtech EF
Data Product support.
5.2.3.3
Serial Interface Used for Firmware Information
Chapter 8. SERIAL INTERFACE OPERATION
Use your terminal emulator program to execute remote queries with the LBC-4000/-ST. Use the
“FRM” or “FRW” remote query to find the pertinent firmware information:
•
<DEV/FRM_{cr}
(returns the current (Ethernet-ready) firmwares running under Boot, Bulk1, and Bulk2 in
the form FW-AAAAAAA; B.B.B; DD/MM/YY, where:
o
FW-AAAAAAA = the firmware part number
o
B.B.B = the firmware version number
o
MM/DD/YY = the firmware release date (Month/Day/Year)
•
<DEV/FRW_{cr}
(returns the legacy (Serial operation only) firmwares in the form:
o
BULK=FW/9965X (where X is the Revision Letter)
o
M&C=FW/9966X (where X is the Revision Letter)
o
FPGA=FW/9967X (where X is the Revision Letter)
