Comtech EF Data CDM-625A, Installation And Operation Manual

Page: 485 / 756

CDM-625A Advanced Satellite Modem MN-CDM625A
CDM-625A ODU (Transceiver, BUC, LNB) Operation Revision 4
10–15
10.3.3.3.3.1 ODU: FSK-control

CSAT
The CSAT menus that follow assume that you have already selected, and the
system has identified, a (standalone) CSAT connected via the rear panel Rx IF port.
When the following menu selections are made:
•
ODU: FSK-control

CSAT
•
ODU: FSK-control

2CSATs

CSAT#1
•
ODU: FSK-control

2CSATs

CSAT#2
You are directed to a common submenu branch:
CSAT-5060/050 V1.02
Configuration Monitor Alarms Info(

)
For clarity, this common submenu branch and its nested menus are defined in this
section. (CSAT#X denotes CSAT#1 or CSAT#2.)
Use the
◄ ►
arrow keys to select Configuration, Monitor, Alarms , or Info , and then press
ENTER .
10.3.3.3.3.1.1 ODU: FSK-control

CSAT (2CSATs

CSAT #X)

Configuration
Configuration settings:
Tx Rx LNA Misc (

)
Use the ◄ ► arrow keys to select Tx , Rx , LNA , or Misc , and then press ENTER .
10.3.3.3.3.1.1.1 ODU: FSK-control

CSAT (2CSATs

CSAT #X)

Configuration

Tx
Tx: Fq=6247.0 MHz Att=23.00 dB Amp=On
Mute=Unmuted Slope: xxx, Cal (

)
Use the
◄ ►
arrow keys to select a setting, and then use the
▲▼
arrow keys to change that
setting:
Selection Setting
Fq (Tx Frequency) 3625-4200 MHz, in steps of 1.0 or 2.5 MHz
At (Tx Attenuation ) 0 to 25 dB, in increments of .25dB
Amp (Amplifier setting ) Off or On