Comtech EF Data CDM-625A, Installation And Operation Manual

Page: 242 / 756

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 4
7–12
7.5.3.1 Conditional Access to IP Packet Processor Pages
Carefully review the information in this section.
There are a significant number of pages in the CDM-625A HTTP Interface that address operation
of the CDM-625A once it is equipped with the optional IP Packet Processor card. These pages
are accessible only when you install and enable the optional IP Packet Processor card.
As specified in Sect. 7.5.1 , access to these pages is further restricted to “Admin” (administrative)
users only . If a user with “Read/Write” or “Read Only” user access privileges attempts to select
any IP Packet Processor-specific page, access to that page is prohibited and either of the
following error messages may display in the browser window:
-or-
Once logged in, if the Admin user attempts to access any IP Packet Processor-specific page when
the optional IP Packet Processor card is not installed , the following message displays:
Click [Back to previous page] to resume use of the interface.
If the Admin user attempts to access these pages when the optional IP Packet Processor card is
installed but card operation is disabled , the following message displays:
Click
[Back to previous page]
to continue any other available operations, or go to the Packet
Processor drop-down list (in the Network Configuration section of the ‘ Configuration | LAN | IP ’
page) to select its operation as Enabled (the modem will automatically reboot).