8-8
User Macros
User macros are a series of commands, defined by the repeater owner. User macros permit the owner
to customize certain aspects of repeater operation. Once the CAT-800 decodes the macro number, the
commands will execute in the order they were stored within the macro string. The CAT-800 supports
forty user macros.
If you clicked on the “BOY AND GIRL” button at the to
p of the main editor window
you will see a window similar to the one below. User macros use the same four digit internal commands
as the event macros. The only difference is a DTMF control code is added. This is the code entered by
the repeater user to execute the macro. This code can be from one to seven digits. When selecting this
code make sure it does not conflict with an existing code in the system. Be sure and check mark the
enable box.
When finished click “OK”.
Paging Tones
If you clicked
on the “RED ANTENNA” button at the top of the main editor window you will see a window
similar to the one below. Use the arrow buttons to select the first and second tones. When finished click
“OK”.
Summary of Contents for CAT-800
