8-7
Voice Synthesizer Messages
If you clicked on the “MICROPHONE” button at the top of the main editor window you will see a window
similar to the one below. Voice
Message #1 is the repeater’s identification. Place the hand on the
message and click. The voice message editor window will appear. Clear the message by clicking the
CLEAR button. Click on the numbers, letters and words in the vertical column to construct a new
voice message. When finished click “OK”.
Event Macros
Event Macros are used to perform custom operations at pre determined times during repeater
operation. There are seven basic types of event macros. They are: Port Activity, Logic Input, Repeater
ID, Load and Play Courtesy Tones, Play Voice Messages, Link Auto Disconnect and Scheduled an Event.
An event macro consists of up to ten four digit internal commands.
If you clicked on the “LIGHTNING”
button at the top of the main editor window you will see a window similar to the one below. Enter the
four-digit internal commands in the order they are to be executed. Be sure and check mark the
enable box. When finished click “OK”.
NOTE: Click on the “Help” button at the top of the main editor window to display the “Table of Internal
Commands”.
The table is also available in this manual on pages 5-2 and 5-3.
Summary of Contents for CAT-800
