Computer Automation Technology CAT-800, Manual

Page: 49 / 105

5-20
Program Paging Tone Locations (01-05)
Key-up and send [*98XX] followed by the paging tone group and tone number. Un-key and the voice
will say: "CONTROL OK." Example: Program [707 - 1395Hz] tones at table position 2.
TWO-TONE SEQUENTIAL PAGING FREQUENCIES (Hz)
Tone Group
1
Group
2
Group
3
Group
4
Group
5
Group
6
1 349.0 600.9 288.5 339.6 584.8 1153.4
2 368.5 634.5 296.5 358.6 617.4 1185.2
3 389.0 669.9 304.7 378.6 651.9 1217.8
4 410.8 707.3 313.0 399.8 688.3 1251.4
5 433.7 746.8 953.7 422.1 726.8 1285.8
6 457.9 788.5 979.9 445.7 767.4 1321.2
7 483.5 832.5 1006.9 470.5 810.2 1357.6
8 510.5 879.0 1034.7 496.8 855.5 1395.0
9 539.0 928.1 1063.2 524.6 903.2 1433.4
0 330.5 569.1 1092.4 321.7 553.9 1122.5
Erase Paging Tone Locations (01-05)
Key-up and send [*99XX]. Un-key and the voice will say: "POSITION XX IS CLEAR."
Audio Test Tone [*901 *902 *903]
The CAT-800 will generate a 1000Hz test tone. Use this tone as a reference when setting the
transmitter audio levels. To activate the tone, as TX1 audio, key-up and enter [*901]. To activate the
tone, as TX2 audio, key-up and enter [*902]. To activate the tone, as TX3 audio, key-up and enter
[*903].
Exit Programming Mode [*0]
To exit the programming mode and return to normal repeater operation, key-up and send [*0]. Un-key
and the voice will say: "CONTROL EXIT." If you fail to exit the programming mode, the CAT-800 will exit
the programming mode when the [*613*] timer expires. The CAT-800 will return to normal operation.
The voice will say: TIMER EXIT."
Program Command First Tone Group
First Tone Number
*98 02 2 4 6 8
Paging Tone Second Tone Number
Table Position Second Tone Group