Computec
CDD5.0
EN
CDD 5.0: user manual – Rev.01
Page 9/63
- Figure 2-2: identification of keys and connections
The controller is equipped with:
N°
ID
Description
1
ON
Power on key
2
OFF
Power off key
3
Display
7-segment display (two digits) to show status/configuration
4
“1” “2” “3” “4”
Functional keys for visualization/movement/programming
5
X8
Plug for upgrade/configuration external device
6
X4
Plug for motor/battery
7
X5
RJ45 plug for motor encoder
8
X9
Direct connection of optical light curtains (including power)
9
X3.1
Plug for Elevator controller commands
10
X3.2
Plug for local inputs of the door operator
11
X2
Plug for drive output to the elevator controller
12
X1
Plug for main power supply
- Table 4: list of connections/keys
2.3
Compatibility for applications and motors
The CDD 5.0 can be applied to all the lift door operators that use the motors reported in the compatibility
table, in particular for that operator for which it is pre-set the configuration of the mechanical transmission
(skate, motor pulley, …).
It is possible in any case to adapt the system configuration to other door operator that uses the same
motors, setting manually the specified parameters values. It is strongly suggested, in this case, to previously
contact directly Computec technical support, for information about compatibility and configuration.