Paper Handling
A78408744-002
39
Cut Sheets
Cut sheets are inserted from the top of the printer. You can load cut sheet
whether fanfold paper is inserted or not.
If no fanfold paper is present, proceed as follows; otherwise, go to "Switching
From Fanfold Paper to Single Sheet" section.
Loading Cut Sheets
1.
Put the paper chute in the raised position by pulling and hooking it
firmly. Close or extend the paper support bar according to the paper size.
2.
If you wish to position the first printing column at 25 mm from the edge
of the paper, slide the left paper guide to the left as far as it will go, then
adjust the right paper guide according to the paper width.
Summary of Contents for 4051 plus
Page 1: ...4051 plus 4056 plus User Manual...
Page 2: ......
