COMPRO NC420, User Manual, Page: 60 / 80

Reset to the Factory Default Settings 9-2
Compro NC420 / NC450
Reset to the Factory Default Settings
If you forget your system password or if you feel your IP camera has been acting weird, you can follow the
steps below to reset the camera to its default settings in which the camera obtains IP from the available local
DHCP server. The reset button of your IP camera is located at the rear end of the camera body (inside the
housing). To access the reset button, you need to open the dome-shaped back cover. In order to do so, first
loosen the plastic hexigonal ring that fastens the cables to the rear end of camera housing, and then unscrew
the screws that fixes the dome-shaped back cover. Then follow the steps below:
1. Press and hold the reset button for about 10 seconds. After the camera is reset, it will take 1 minute to
reboot. Please wait patiently.
2. Start the iWizard Utility again to scan for and re-configure your Compro IP camera.
Reset
Figure 9-2. Reset button